發布時間：2018-08-14 18:28

【摘要】：碳酸鈣、高嶺土、二氧化鈦、滑石粉等是造紙行業中常用的幾種填料。填料的使用不僅可以有效降低制造成本,同時可以改善紙張的光學性能、物理性能及書寫可適性。二氧化鈦是眾多造紙?zhí)盍现行阅茏詈玫囊环N,但因其價格昂貴,限制其使用范圍。因此制備以二氧化鈦為包覆層、以廉價無機礦物質為內核的復合粉體一直以來都是研究人員追求的目標。本文采用碳酸化法制備以CaCO3為沉淀層的高嶺土-碳酸鈣(Kaolin-CaCO3);以Ti02為包覆層的高嶺土-二氧化鈦(Kaolin-TiO2);以CaCO3為內核,Ti(SO4)2為鈦源,尿素為沉淀劑,制備具有核殼結構的碳酸鈣@二氧化鈦(CaCO3@TiO2)。并通過XRD、 FESEM、 UV、 FT-IR、 XPS等一系列檢測手段加以驗證。此外,對三種復合粉體進行漿料Zeta電位、留著率、白度等紙張性能的測試,確定最佳填料配比：Kaolin-CaCO3復合體系中,當Kaolin質量分數介于20～60%時,填料的留著性能,紙張白度值均較好；Kaolin-TiO2復合體系中,當Kaolin質量分數為40%時,填料留著效果最佳,紙張白度良好；對于CaCO3@Ti02復合體系,當CaCO3含量為40%時,填料留著效果與紙張白度均最佳。
[Abstract]:Calcium carbonate, kaolin, titanium dioxide and talc powder are some kinds of fillers commonly used in paper industry. The use of fillers can not only reduce the manufacturing cost, but also improve the optical, physical and writing properties of paper. Titanium dioxide (TIO _ 2) is one of the best fillers for paper making, but its application range is limited because of its high price. Therefore, the preparation of composite powders with titanium dioxide as the coating layer and cheap inorganic minerals as the core has always been the goal pursued by researchers. In this paper, Kaolin calcium carbonate (Kaolin-CaCO3) with CaCO3 as precipitating layer, kaolinite-titanium dioxide (Kaolin-TiO2) with Ti02 as coating layer and CaCO3 as core Ti (SO4) 2 as titanium source and urea as precipitant to prepare core-shell calcium carbonate @ titania (CaCO3@TiO2) were prepared by carbonation method. It is verified by XRD, FESEM, UV, FT-IRand XPS and so on. In addition, the Zeta potential, retention rate, whiteness and other paper properties of the three kinds of composite powders were tested, and the optimum filler ratio was determined. When the mass fraction of Kaolin was between 20 and 60, the retention performance of the filler was determined. In the Kaolin-TiO _ 2 composite system, when the Kaolin content is 40, the packing effect is the best and the paper whiteness is good. For the CaCO3@Ti02 composite system, when the CaCO3 content is 40, the retention effect of the filler and the whiteness of the paper are the best.
【學位授予單位】：吉林大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TB33;TS727

【參考文獻】

相關期刊論文 前10條

1 ;Preparation of calcium carbonate particles coated with titanium dioxide[J];International Journal of Minerals Metallurgy and Materials;2009年05期

2 姚超,張智宏,林西平,汪信;納米技術與納米材料(V)——防曬化妝品中的納米二氧化鈦[J];日用化學工業;2003年05期

3 殷海榮;武麗華;陳福;馬亮;亓豐源;;納米高嶺土的研究與應用[J];材料導報;2006年S1期

4 郭奮,高立東,劉潤靜,趙永華,梁磊,陳建峰;高嶺土/鈦白復合粉體的制備與表征[J];材料科學與工藝;2001年04期

5 張國富;朱燕娟;熊惠芳;張偉;王濤;謝紅波;;高嶺土黏度的影響因素及測試方法改進探討[J];非金屬礦;2006年03期

6 趙麗娜;王秀艷;孔治國;王子忱;;枝狀文石型碳酸鈣的仿生合成及在PVC中的應用[J];高等學�；瘜W(xué)學報;2010年12期

7 唐宏科,陳均志;重鈣作為造紙?zhí)盍系谋砻娓男訹J];廣東造紙;2000年02期

8 周銳;郭子坤;謝宇鷹;;沉淀碳酸鈣在涂布白紙板涂料上的應用研究[J];造紙科學與技術;2007年04期

9 張春梅,何北海;紙漿懸浮液電荷分析評價及其應用[J];廣東造紙;1998年03期

10 丁士育,金鑫,陳欣;改性納米碳酸鈣粉體的制備及其耐酸性[J];硅酸鹽學報;2005年03期

相關博士學位論文 前1條

1 程金蘭;填料物理化學特性對留著性能的影響[D];南京林業大學;2009年

，

本文編號：2183733