發布時間：2018-01-24 20:44

  本文關鍵詞： 開關磁阻電機 轉矩波動 非線性 有限元分析 靜態特性　出處：《重慶交通大學》2015年碩士論文　論文類型：學位論文

【摘要】：開關磁阻電機(SRM)因其結構簡單、成本低廉、調速范圍廣等突出特點而廣受企業和研究人員的關注,但轉矩波動和噪聲也是其兩大不可忽視的缺點。為了提高開關磁阻電機的性能,拓寬其應用領域,轉矩波動抑止研究和控制參數優化成為開關磁阻電機深入研究的熱點,而電磁特性的精確計算則是其中的重要基礎。開關磁阻電機的特殊結構以及電磁材料的非線性導致其內部電磁場是高度非線性變化的,加之磁場復雜的邊界條件,選擇合適的計算模型和方法尤為重要,而有限元法(FEM)無疑是一種有效的手段,為此采用ANSYS軟件對開關磁阻電機電磁場進行有限元計算。根據樣機提供的基本數據,再通過電機設計經驗公式可以計算出開關磁阻電機的具體結構參數,這些參數為構建有限元模型提供幾何數據。通過ANSYS有限元求解和后處理得到的各磁場參數分布云圖,可以得出開關磁阻電機的電磁場分布規律是非線性的,各磁場參數的具體值不僅與繞組電流有關,還隨著轉子的位移角變化而變化。開關磁阻電機靜態特性的計算基礎是磁化曲線(Ψ-i-θ曲線)�；�于電磁場的基本理論和方程,利用ANSYS內部的宏命令可以計算不同電流密度載荷以及不同轉子位移角時的磁鏈,得到磁化曲線。通過對磁化曲線的分析可以得出開關磁阻電機的磁鏈?zhǔn)请S電流和轉子位移角而非線性變化,并且變化趨勢還受到磁路飽和效應的影響。通過對在磁化曲線基礎上得出的轉矩特性分析可知,開關磁阻電機的轉矩在初始位置達到了最大,開通角提前開啟可以使開關磁阻電機在較短的時間內達到最大的電磁轉矩;轉矩波動與電流的大小有關,電流越大波動幅度越大,轉矩特性曲線變化趨勢也越劇烈。電流密度為3A/mm2時,電磁轉矩的峰值最小,轉矩波動最小,轉矩特性曲線也最為平滑;電流密度為7A/mm2時,電磁轉矩的峰值最大,轉矩波動也最大,轉矩特性曲線變化趨勢最劇烈;電流密度為5A/mm2時,轉矩峰值和波動介于兩者之間,開關磁阻電機既具有較大的電磁轉矩,又具有較小的轉矩波動。
[Abstract]:Switched reluctance motor (SRM) has attracted the attention of enterprises and researchers because of its simple structure, low cost and wide speed range. In order to improve the performance of switched reluctance motor (SRM) and broaden its application field, torque ripple and noise are also two shortcomings that can not be ignored. Torque ripple suppression and control parameter optimization have become a hot spot in the research of switched reluctance motor (SRM). The accurate calculation of electromagnetic characteristics is an important foundation. The special structure of switched reluctance motor and the nonlinearity of electromagnetic materials lead to the highly nonlinear variation of the internal electromagnetic field. In addition, due to the complex boundary conditions of magnetic field, it is very important to choose the appropriate calculation model and method, and the finite element method (FEMM) is undoubtedly an effective method. For this reason, the electromagnetic field of switched reluctance motor is calculated by using ANSYS software, and the basic data provided by the prototype are given. Then the structural parameters of switched reluctance motor can be calculated by the empirical formula of motor design. These parameters provide geometric data for building the finite element model. The distribution of magnetic field parameters is obtained by ANSYS finite element solution and post-processing. It can be concluded that the electromagnetic field distribution law of switched reluctance motor is nonlinear, and the specific value of each magnetic field parameter is not only related to winding current. The static characteristics of switched reluctance motor (SRM) are calculated on the basis of magnetization curve (蠄 -i- 胃 curve), based on the basic theory and equation of electromagnetic field. The flux chains with different current density loads and different rotor displacement angles can be calculated by using the macro commands in ANSYS. Through the analysis of the magnetization curve, it can be concluded that the flux of switched reluctance motor is nonlinear with the current and rotor displacement angle. And the change trend is also affected by the saturation effect of magnetic circuit. Through the analysis of torque characteristics obtained on the basis of magnetization curve, the torque of switched reluctance motor reached the maximum in the initial position. The switched reluctance motor can reach the maximum electromagnetic torque in a short time by opening the switch angle in advance. Torque ripple is related to the magnitude of current. The larger the current is, the more the variation trend of torque characteristic curve is. When the current density is 3A / mm2, the peak value of electromagnetic torque is the minimum, and the torque fluctuation is minimum. The torque characteristic curve is the smoothest. When the current density is 7A / mm2, the peak value of electromagnetic torque is the biggest, the torque ripple is the biggest, and the change trend of the torque characteristic curve is the sharpest. When the current density is 5A / mm2, the torque peak and fluctuation are between them. The switched reluctance motor (SRM) has both larger electromagnetic torque and smaller torque ripple.
【學位授予單位】：重慶交通大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TM352

【參考文獻】

相關期刊論文 前2條

1 付光杰;甄東芳;邵海龍;;基于有限元分析的開關磁阻電動機非線性研究[J];科學技術與工程;2009年15期

2 鄧智泉,楊鋼,張媛,曹鑫,王曉琳;一種新型的無軸承開關磁阻電機數學模型[J];中國電機工程學報;2005年09期

，

本文編號：1460971