發布時間：2018-01-26 10:49

  本文關鍵詞： 鋰動力電池 電池不一致性 雙向均衡 反激式變壓器　出處：《吉林大學》2014年碩士論文　論文類型：學位論文

【摘要】：由于電池單體間不一致性的存在，當單體鋰動力電池經過串并聯應用于純電動汽車后，性能較差的電池較早的達到充放電截止電壓造成電池組的容量利用率下降，降低純電動汽車?yán)m(xù)駛里程，增加純電動汽車使用成本，不利于純電動汽車的使用與推廣。本文所研究的均衡技術通過實時監測電池組在使用過程中的狀態信息來對電池組進行均衡管理，能改善電池組使用過程中的不一致性產生的影響，提高電池組的容量利用率，減緩電池老化速度，延長電池組的使用壽命，增加電動汽車?yán)m(xù)駛里程。 本文以對鋰動力電池組不一致性的機理分析為基礎，設計均衡系統，并完成系統軟硬件設計，最后進行試驗驗證。研究內容如下： 1.從生產制造過程、使用過程、儲存過程三個方面對鋰動力電池組的不一致產生和惡化的原因進行機理分析，總結目前應用于改善電池組不一致性的解決方法；闡述均衡技術對于緩解電池在使用過程中不一致性的惡化，有效提高電池組使用壽命的重要意義。通過對鋰動力電池進行相關試驗，分析不同電池特性參數（電壓、內阻、SOC）對于電池組不一致性問題的表現形式，選取開路電壓作為擱置階段的均衡變量，工作電壓作為電池組充放電階段的均衡變量。 2.對常見均衡電路拓?fù)浣Y(jié)構的優缺點進行對比分析，選取基于反激式變壓器的能量非耗散型均衡拓?fù)浣Y(jié)構。并對反激式變壓器的基本參數進行計算，搭建均衡仿真電路，選取電路控制參數。 3.選取電壓極差作為均衡進入與退出的判斷依據，，根據相關電池試驗和電路要求，確定相應的控制閥值；針對電池組不同的工作階段提出充電均衡、放電均衡和擱置均衡三種控制策略，利用均衡系統模型對均衡控制策略進行仿真驗證。 4.以“主-從”分布式結構作為均衡系統的總體架構，完成電源模塊、電壓采集模塊、電流采集模塊、均衡模塊以及通信模塊的硬件電路設計，然后完成系統的軟件設計。 5.完成系統調試，獲得均衡電路在頂部均衡和底部均衡時的實際調試結果，與仿真結果進行了對比分析，然后通過擱置階段和充放電階段的臺架試驗驗證均衡系統在電池組不同工作階段對于改善電池組不一致性的控制效果。
[Abstract]:Because of the inconsistency between the cell units, when the lithium battery is used in the pure electric vehicle after series-parallel connection. The lower battery performance reached the charge / discharge cutoff voltage earlier, which led to the decrease of battery pack capacity utilization, reduced the driving range of pure electric vehicle, and increased the use cost of pure electric vehicle. It is not conducive to the use and promotion of pure electric vehicle. The equalization technology studied in this paper can manage the battery pack by monitoring the state information of battery pack in the process of using in real time. It can improve the influence of inconsistency in battery pack use, increase the capacity utilization ratio of battery pack, slow down the aging speed of battery, prolong the service life of battery pack, and increase the driving distance of electric vehicle. Based on the analysis of the mechanism of lithium power battery pack inconsistency, this paper designs the equalization system, designs the software and hardware of the system, and finally carries on the test verification. The research contents are as follows: 1. Analyze the causes of the inconsistency and deterioration of lithium power battery from three aspects: manufacturing process, use process and storage process. Summarize the current solutions to improve battery pack inconsistency; This paper expounds the importance of equalization technology in alleviating the deterioration of the inconsistency during the use of the battery and effectively increasing the service life of the battery pack. This paper analyzes the performance of different cell characteristic parameters (voltage, internal resistance) to the battery pack inconsistency, and selects the open circuit voltage as the equalization variable in the shelving stage. The working voltage is used as the equalization variable of battery charge and discharge stage. 2. The advantages and disadvantages of common equalization circuit topology are compared and analyzed. The energy non-dissipative equalization topology based on flyback transformer is selected, and the basic parameters of flyback transformer are calculated. Set up the equalization simulation circuit, select the control parameters of the circuit. 3. Selecting the voltage range as the basis for judging the equalization of entry and exit, according to the battery test and circuit requirements, determine the corresponding control threshold; Three control strategies, charging equalization, discharge equalization and shelving equalization, are proposed for different working stages of the battery pack. The equalization control strategy is verified by simulation using the equalization system model. 4. Taking the "master-slave" distributed structure as the overall structure of the equalization system, the hardware circuit design of the power supply module, voltage acquisition module, current acquisition module, equalization module and communication module is completed. Then the software design of the system is completed. 5. The system debugging is completed, and the actual debugging results of the equalization circuit in the top and bottom equalization are obtained, and the results are compared with the simulation results. Then the control effect of the equalization system in different working stages of the battery pack is verified by the bench tests in the shelving stage and the charging and discharging stage.
【學位授予單位】：吉林大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM912;U469.72

【參考文獻】

相關期刊論文 前10條

1 王震坡;孫逢春;林程;;不一致性對動力電池組使用壽命影響的分析[J];北京理工大學學報;2006年07期

2 伊廷鋒;岳彩波;朱彥榮;諸榮孫;胡信國;;動力鋰離子電池正極材料的研究評述[J];稀有金屬材料與工程;2009年09期

3 吳雪平;;鋰離子電池生產過程中的重要質量管控點[J];電池;2008年05期

4 張賓;林成濤;陳全世;;動力鋰離子電池離散特性分析與建模[J];電池工業;2008年02期

5 王棟,張燕,張文學;從磁路角度分析反激變換器效率低的主要原因[J];電力電子技術;2005年03期

6 沈躍;蘇義腦;李林;李根生;;反激式變換器的能量傳輸與電路狀態分析[J];電力電子技術;2009年02期

7 符曉玲;商云龍;崔納新;;電動汽車電池管理系統研究現狀及發展趨勢[J];電力電子技術;2011年12期

8 宋永華;陽岳希;胡澤春;;電動汽車電池的現狀及發展趨勢[J];電網技術;2011年04期

9 王佳元;孫澤昌;魏學哲;戴海峰;;電動汽車動力電池分選方法研究[J];電源技術;2012年01期

10 姜國權;朱建新;申其壯;;基于模糊控制的動力鋰電池均衡系統[J];電子技術;2008年07期

本文編號：1465396