機車雨刮器LLC軟開關電源的研究
發布時間：2018-12-14 11:23
【摘要】：隨著現代交通運輸業的發展以及鐵路電氣化的大量普及,電力機車的應用越來越廣泛。機車雨刮器是電力機車一個重要組成部件,直接影響司機前方的視野,目前雨刮器普遍存在故障率高、不穩定的問題,將給機車運行造成安全隱患。傳統的機車雨刮器采用的電機是兩臺100W的110V非標準直流電機,所以雨刮器電機的成本比較高。本文所研究設計的軟開關電源適配給采用兩臺24V普通直流電機的機車雨刮器,這樣極大的降低了雨刮器電機的成本,具有極高的研究價值及意義。電源采用了LLC諧振軟開關的結構用以提高電源效率,輸出級采用了同步整流技術,較之傳統的肖特基二極管(SBD)或快恢復二極管(FRD)整流,采用同步整流技術的開關電源的開關損耗極低,大大提高了整機的效率。同時,機車雨刮器的維護也是機車維護的重點,本文所設計的電源體積小易于實現模塊化,電源具有自我保護功能、安全系數高、安裝更換方便等優點。文章對設計的雨刮器電源拓撲結構的原理進行了詳細分析,尤其對LLC諧振變換器主電路部分和驅動電路部分進行了優化設計,對電源的主要參數,如變壓器、諧振腔、采樣電路等參數進行了詳細的計算,從而使樣機各項參數達到最優,應用Altium Designer Winter 09進行樣機原理圖和PCB的設計,然后調試樣機,最后對樣機進行波形測試,從測試波形和數據可知,樣機開關損耗低,效率高,性能指標達到預期效果。結合以上的工作,本文設計的基于TEA1716的DC110/DC24V的200W軟開關電源,輸出級采用TEA1995控制的全波同步整流電路,電源具有明顯的優越性,有著良好的市場應用前景。
[Abstract]:With the development of modern transportation and the popularization of railway electrification, electric locomotives are used more and more widely. Locomotive wiper is an important component of electric locomotives, which directly affects the sight of the driver. At present, the wiper has the problems of high failure rate and instability, which will cause hidden trouble to the locomotive operation. The traditional locomotive wiper adopts two 100W 110V nonstandard DC motors, so the cost of wiper motor is high. The soft switching power supply designed in this paper is suitable for locomotive wiper with two 24V ordinary DC motors, which greatly reduces the cost of wiper motor and has high research value and significance. The power supply adopts the structure of LLC resonant soft switch to improve the efficiency of power supply, the output stage adopts synchronous rectifier technology, compared with the traditional Schottky diode (SBD) or fast recovery diode (FRD) rectifier, The switching loss of the switching power supply using synchronous rectifier technology is very low, which greatly improves the efficiency of the whole machine. At the same time, the maintenance of locomotive wiper is also the focus of locomotive maintenance. The power supply designed in this paper is easy to realize modularization in small volume, with the advantages of self-protection, high safety factor, convenient installation and replacement, and so on. In this paper, the principle of the topology of the wiper power supply is analyzed in detail, especially the main circuit and driving circuit of the LLC resonant converter are optimized, and the main parameters of the power supply, such as transformer, resonator, are optimized. The sampling circuit and other parameters are calculated in detail, so that the parameters of the prototype are optimized. The prototype schematic diagram and PCB are designed by using Altium Designer Winter 09, then the prototype is debugged, and the waveform of the prototype is tested. From the test waveform and data, it can be seen that the switch loss of the prototype is low, the efficiency is high, and the performance index reaches the expected effect. Combined with the above work, the 200W soft switching power supply based on DC110/DC24V based on TEA1716 is designed in this paper. The output stage adopts the full wave synchronous rectifier circuit controlled by TEA1995. The power supply has obvious advantages and has a good market application prospect.
【學位授予單位】：湖南工業大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：U260.4;TN86
本文編號：2378531
[Abstract]:With the development of modern transportation and the popularization of railway electrification, electric locomotives are used more and more widely. Locomotive wiper is an important component of electric locomotives, which directly affects the sight of the driver. At present, the wiper has the problems of high failure rate and instability, which will cause hidden trouble to the locomotive operation. The traditional locomotive wiper adopts two 100W 110V nonstandard DC motors, so the cost of wiper motor is high. The soft switching power supply designed in this paper is suitable for locomotive wiper with two 24V ordinary DC motors, which greatly reduces the cost of wiper motor and has high research value and significance. The power supply adopts the structure of LLC resonant soft switch to improve the efficiency of power supply, the output stage adopts synchronous rectifier technology, compared with the traditional Schottky diode (SBD) or fast recovery diode (FRD) rectifier, The switching loss of the switching power supply using synchronous rectifier technology is very low, which greatly improves the efficiency of the whole machine. At the same time, the maintenance of locomotive wiper is also the focus of locomotive maintenance. The power supply designed in this paper is easy to realize modularization in small volume, with the advantages of self-protection, high safety factor, convenient installation and replacement, and so on. In this paper, the principle of the topology of the wiper power supply is analyzed in detail, especially the main circuit and driving circuit of the LLC resonant converter are optimized, and the main parameters of the power supply, such as transformer, resonator, are optimized. The sampling circuit and other parameters are calculated in detail, so that the parameters of the prototype are optimized. The prototype schematic diagram and PCB are designed by using Altium Designer Winter 09, then the prototype is debugged, and the waveform of the prototype is tested. From the test waveform and data, it can be seen that the switch loss of the prototype is low, the efficiency is high, and the performance index reaches the expected effect. Combined with the above work, the 200W soft switching power supply based on DC110/DC24V based on TEA1716 is designed in this paper. The output stage adopts the full wave synchronous rectifier circuit controlled by TEA1995. The power supply has obvious advantages and has a good market application prospect.
【學位授予單位】：湖南工業大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：U260.4;TN86
【相似文獻】
相關期刊論文 前3條
1 李和明;張智娟;彭詠龍;李亞斌;;多相并聯LLC電壓型諧振逆變電源控制與調節[J];電力系統自動化;2010年11期
2 高又春;吳玉香;;一種改進的LLC電路在交流電源中的應用研究[J];電測與儀表;2010年07期
3 廖政偉;張雪;尤偉;姚瑋;呂征宇;;應用于超寬輸入范圍的變拓撲LLC電路[J];浙江大學學報(工學版);2013年12期
相關碩士學位論文 前7條
1 申彥峰;用于獨立光伏發電系統的LLC集成型三端口直流變換器研究[D];燕山大學;2015年
2 宋川;LLC光伏功率均衡器的研究[D];北方工業大學;2016年
3 皮松濤;機車雨刮器LLC軟開關電源的研究[D];湖南工業大學;2017年
4 戴幸濤;LLC變換器軟開關特性及諧振參數優化研究[D];哈爾濱工業大學;2012年
5 廖家文;LLC變流器優化設計及其同步整流技術研究[D];浙江大學;2011年
6 王鑫;多路輸出LLC串并聯諧振電路PCB電磁兼容的研究[D];北京交通大學;2012年
7 靳芳閣;GPRS撥測系統中LLC協議的研究與實現[D];北京郵電大學;2013年
，本文編號：2378531
本文鏈接：http://www.wukwdryxk.cn/shoufeilunwen/xixikjs/2378531.html
最近更新
教材專著
