發布時間：2018-09-18 14:30

【摘要】：傳統電力系統設備因其不具備靈活功率流控制、無法實現能量多節點雙向傳輸、難以提供多樣化供電形式的特點,難以滿足未來智能電網發展需求。基于電力電子技術發展而來的固態變壓器等各類電力電子變換裝置,不但能為各類可再生能源及儲能系統提供豐富互聯接口,還將為未來電網潮流智能分配管理和多端能量變換提供靈活控制方法。本文研究了一種應用于未來智能電網的交流三端口變換器,完成以下工作:介紹了固態變壓器的發展歷程及出現的典型拓撲結構,在此基礎上給出了交流三端口變換器采用高壓級聯整流級、中間隔離DC-DC變換級和低壓逆變輸出級三級式拓撲結構。針對三電平H橋單模塊和單相級聯變換器,分別建立其開關等效電路,推導電路方程表達式;針對雙向半橋三電平DC-DC拓撲結構,分析其工作原理并推導其在移相控制條件下的功率傳輸特性。研究了適合級聯整流級的三相DQ解耦控制策略,在模塊間采用載波移相調制及模塊內采用反相載波層疊調制的基礎上,增加冗余開關選擇,解決了三電平H橋多電平模塊分電容電壓均衡問題;針對中間級三電平半橋DC-DC變換器,應用雙邊三電平移相控制方式,推導不同模式功率傳輸特性,研究了一種輕載效率較高的中間隔離DC-DC變換級控制策略。在上述研究的基礎上,搭建了交流三端口變換器系統MATLAB/Simulink仿真模型,仿真了輸入級在系統啟動和負載變化過程的動態特性,帶載工作時網側電流正弦性、單位功率因數運行等穩態性能;其次仿真了中間級采用雙邊三電平控制的工作原理和功率傳輸特性,并對比仿真驗證了輕載時采用傳統移相控制、單邊三電平控制和雙邊三電平控制時各自流過中頻變壓器電流的大小;最后模擬了兩個低壓端口與高壓端口之間的功率傳輸特性。在理論研究和仿真驗證的基礎上,構建了由三相整流和隔離DC-DC構成的能量交互小功率實驗平臺,完成基于FPGA芯片控制程序設計,給出了系統動靜態性能,分別實驗驗證了三相級聯整流器、隔離DC-DC變換器及多端口能量交互系統電路拓撲和控制策略的正確性及可行性。
[Abstract]:Because of its lack of flexible power flow control, the traditional power system equipment can not realize the two-way transmission of energy multi-node, it is difficult to provide a variety of power supply forms, and it is difficult to meet the development needs of smart grid in the future. Based on the development of power electronics technology, solid state transformers and other power electronic conversion devices can not only provide a rich interconnection interface for all kinds of renewable energy and energy storage systems, It will also provide a flexible control method for the future power flow intelligent allocation management and multi-terminal energy conversion. In this paper, an AC three-port converter applied in the future smart grid is studied. The following works are accomplished: the development of solid-state transformer and its typical topology are introduced. On this basis, the three-port AC converter with high voltage cascade rectifier stage, intermediate isolated DC-DC transform stage and low voltage inverter output stage is presented. For three-level H-bridge single-module and single-phase cascaded converters, the switching equivalent circuits are established, and the expressions of circuit equations are derived, and the bi-directional half-bridge three-level DC-DC topology is analyzed. Its working principle is analyzed and its power transmission characteristics under phase shift control are deduced. The decoupling control strategy of three-phase DQ suitable for cascaded rectifier stage is studied. On the basis of adopting carrier phase shift modulation between modules and inverse-phase carrier stacked modulation in module, the selection of redundant switch is increased. The voltage equalization problem of three-level H-bridge multilevel module is solved, and for the intermediate three-level half-bridge DC-DC converter, the power transmission characteristics of different modes are deduced by using the bilateral three-level phase-shift control mode. An intermediate isolated DC-DC transform level control strategy with high light load efficiency is studied. On the basis of the above research, the simulation model of AC three-port converter system MATLAB/Simulink is built, and the dynamic characteristics of input stage during system startup and load change are simulated, and the sinusoidal characteristics of grid-side current when working under load are simulated. The steady-state performance such as unit power factor operation is simulated. Secondly, the operation principle and power transmission characteristics of the intermediate stage using two-sided three-level control are simulated, and compared with the simulation results, the traditional phase-shifting control is used when the load is light. At last, the power transmission characteristics between the two low-voltage ports and the high-voltage ports are simulated. On the basis of theoretical research and simulation verification, a small power experiment platform of energy exchange composed of three-phase rectifier and isolated DC-DC is constructed. The control program based on FPGA chip is designed, and the dynamic and static performance of the system is given. The correctness and feasibility of the circuit topology and control strategy of three-phase cascade rectifier isolated DC-DC converter and multi-port energy interactive system are verified by experiments.
【學位授予單位】：西南交通大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TM46

【參考文獻】

相關期刊論文 前10條

1 舒澤亮;馬偉天;柳明;陳亞軍;何曉瓊;;中點鉗位型H橋級聯單相變換器均壓SVPWM最優工作點轉移路徑研究[J];中國電機工程學報;2016年13期

2 宗升;何湘寧;吳建德;李武華;趙榮祥;;基于電力電子變換的電能路由器研究現狀與發展[J];中國電機工程學報;2015年18期

3 王X;游小杰;王琛琛;周明磊;;低開關頻率下SHEPWM和SVPWM同步調制策略比較研究[J];電工技術學報;2015年14期

4 田世明;欒文鵬;張東霞;梁才浩;孫耀杰;;能源互聯網技術形態與關鍵技術[J];中國電機工程學報;2015年14期

5 吳劍;石健將;張至愚;;三相模塊級聯型固態變壓器均壓/均功率控制策略研究[J];電源學報;2015年02期

6 鄭澤東;顧春陽;李永東;高志剛;;采用多繞組高頻變壓器的新型多電平變換器拓撲及控制策略[J];電工技術學報;2014年10期

7 周孝信;魯宗相;劉應梅;陳樹勇;;中國未來電網的發展模式和關鍵技術[J];中國電機工程學報;2014年29期

8 董朝陽;趙俊華;文福拴;薛禹勝;;從智能電網到能源互聯網:基本概念與研究框架[J];電力系統自動化;2014年15期

9 王琨;馮琳;李國杰;;一種適用于飛跨電容型多電平逆變器的新型載波同相層疊PWM方法[J];電力系統保護與控制;2014年14期

10 查亞兵;張濤;黃卓;張彥;劉寶龍;黃生俊;;能源互聯網關鍵技術分析[J];中國科學:信息科學;2014年06期

，

本文編號：2248209